It is possible to make vMX nodes boot up with a user-defined startup-config instead of a built-in one. Vr-vmx nodes come up with a basic configuration where only the control plane and line cards are provisioned, as well as the admin users and management interfaces such as NETCONF, SNMP, gNMI. Features and options # Node configuration # Operating Systems which are typically used to test network features and vMX. These addresses can be used to reach the management plane of the router.ĭata interfaces eth1+ need to be configured with IP addressing manually using CLI/management protocols. Cisco CISCO1941/K9 1941 2 Port IP Base Gigabit Router - SAME DAY SHIPPING. When containerlab launches vr-vmx node, it will assign IPv4/6 address to the eth0 interface. eth2+ - second and subsequent data interface.eth1 - first data interface, mapped to a first data port of vMX line card. eth0 - management interface connected to the containerlab management network.Vr-vmx container can have up to 90 interfaces and uses the following mapping rules: Cumulus Linux (docker runtime) and Hostĭefault user credentials: Interfaces mapping #.5-stage SR Linux based Clos fabric with config engine.Juniper vMX Juniper vMX Table of contents.
0 Comments
Leave a Reply. |